ok so i'm gonna paint my oem fog light lenses. They are almost taken apart except i can't get the screw out that holds the lense in. it just spins. I saw somewhere that you drill a hole and use something to apply pressure but not sure where to drill the hole. Ready to bake them that is all that is holding me up.
ok so i'm gonna paint my oem fog light lenses. They are almost taken apart except i can't get the screw out that holds the lense in. it just spins. I saw somewhere that you drill a hole and use something to apply pressure but not sure where to drill the hole. Ready to bake them that is all that is holding me up.
What did you end up doing to fix it?
I drilled a small indention next to the screw then I used a small flat head to apply leverage then unscrewed them.
Nice thinking, can't wait to see the end result of the HL.
i missed the initial thread. i would like to see a DIY writen up..... could benefit the community